Don’t let changes in your vision compromise your ability to make the shot. The revolutionary Super Hunter Peep System provides big 1/8" or 1/4" apertures for a bright view. The screw-in Verifier lenses sharpen the picture so pins and quarry are easy to see.


How the Verifiers work:
* As good eyes get older the focal length changes for them to focus on close up objects.
* The Verifier peep has a lens in it similar to the ones in your reading glasses that will allow you to see your sight pins better on your hunting sight.
* There are four different powers available that will match up with most individual's eyes.
* The idea is to match the one that will sharpen you pins but will not take the target out of focus to much.
* Everybody's eyes are slightly different and as you get older your requirements will change.
* The Verifier peep only gives you enough magnification to see the pins but it will not magnify the target because the focal length (the distance between your eye and the peep) is too short to enhance the target.
* There are two different diameters available at this time 1/8" and ¼". These two diameters will work with most applications. Many of the new hunting pin sights are using a round pin guard. The peep should be the right size as to match up with diameter of the pin guard. This will make your anchor more consistent and make for a more accurate shot.
* The Verifier should not be confused with the clarifier that is used to clear up the image in a magnified scope. The Verifier is only used with pins.
* The 1/8" Verifier will fit all of the older and present super peeps.
* Specialty Archery part number 750 Hunter peep kit consists of a 37 degree peep body, a cable key, 14 inches of silicone rubber tubing, a 1/8" screw in peep aperture and an installation wrench. All of the regular size peep apertures and the clarifiers will fit this peep body.
* Specialty Archery part number 753 Hunter peep kit consists of a 37 degree peep body, a cable key, 14 inches of silicone rubber tubing, a ¼ " to 1/8" peep reducer bushing and a duel size installation wrench.
* The Hunter peep body is made from high performance ultra-lightweight Lexan T.M. polycarbonate. This material is used to make bulletproof glass and is as strong as steel. You can remove the tang off the back that holds the rubber tubing by trimming it off with a pair of side cutter pliers which will eliminate the rubber.
* The weight of the 753 peep body with the tang is 22 grains and without the tang it is 15 grains. The weight of the 750 hunter peep body with the tang is 23 grains and with out the tang it is 17 grains. The Super Ball peep weights 11 grains.
* The Verifier will not work well if you have stigmatism or if you are near sighted. Some individuals that wear contacts for these problems have had success with the Verifier.


The Aperture Kit includes Hood Peep, Rubber Tubing, Peep Wrench
The 1/8" 37 degree is the Model 750, the 1/4" 37 degree is Model 753
Verifiers sold seperately